Peumatic Grouting pump is designed for pressure and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes to be able to reinforce the loose rock mass. The most grain size can’t exceed zero.2 mm.
Grouting pump operation and upkeep is straightforward, safe and dependable. This pump is utilized in mines operating under troublesome conditions as a outcome of it’s reliable and explosion-proof.
Basic Pneumatic Grouting pump embody: An air inlet, the pneumatic cylinder, mounting base body and stand, stress gauge, pumping cylinder, outlet with fast launch coupling and wheels.
How it actually works
Pneumatic strain in the air cylinder exerts a high pressure on the grout mixture which finally ends up in ejection of grout with a excessive strain and velocity. The valves of the air cylinder in the pump function routinely to actuate the cylinder. The pneumatic cylinder then strikes the plunger up and down to complete the pumping cycle.
Pneumatic grout pump can be driven even without Electrical energy supply in remote areas by using engine pushed compressor.
Applications
The pump is majorly used in development and mining industry for injecting materials into wide and medium dimension hole in beams, columns ,basement walls and flooring, raise shaft concrete wall fill-up and so forth. In mining trade it is used to replenish cement solution the place there is a hole exists between structure and rock and for soil stabilization.
Detachable design tends to easy upkeep and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is widely used in tunnels, coal mine, bridges and dams, constructing foundation, and different underground tasks, and inflammable, explosive sites and different dangerous setting.
It has utility in chemical industry additionally to pump out chemical slurries.
The pump is electricity free so, can be used at any website situation whether it’s rural or urban.
Mining Pneumatic Grouting pump has a bigger discharge slurry adjustment vary. Generally the ultimate amount of the grouting volume is 8 or10 times of the amount at first. And the final grouting quantity proves that filling is compacted.
Simply put; เกจวัดแก๊สlpg -pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s strain and flow can be adjusted according to the necessities of grouting,(The flow of grouting pump is 0-100L/min, pressure of discharge is 0-10MPa).apart from, This Pneumatic high-pressure grouting pump can be used for grouting single or double fluid.
High-pressure grouting pump is mainly used for highways, railways, water and electricity, development, mining and so on. ground/underground building.
Benefits
Mining Pneumatic Grouting pump has the benefits of low vitality consumption, small vibration, low noise, small size, excessive efficiency, dependable efficiency, pressure and circulate control, lengthy life and so on. Common mine grouting pump has pneumatic injection pump, twin fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can be Light weight and with a wheelie design it may be carried easily. It is designed for easy operation and low upkeep. Last however not least its spare elements are easily obtainable.
Share